3D Hobby Shop 70 AJ SLICK 조립 설명서 - 페이지 9

{카테고리_이름} 3D Hobby Shop 70 AJ SLICK에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Hobby Shop 70 AJ SLICK 19 페이지.

9
Install the rudder servo, servo arm, and ball links with locking nuts as shown.
The rudder pull-pull cables are assembled as shown in the diagram. Crimp the crimp tubes firmly
with pliers, and use a drop of thin CA glue on each crimp tube after you are done crimping.
Crimp the servo end of the cables first. The cables cross once inside the fuselage to form an "X".