3D Hobby Shop 70 AJ SLICK Montagehandleiding - Pagina 7
Blader online of download pdf Montagehandleiding voor {categorie_naam} 3D Hobby Shop 70 AJ SLICK. 3D Hobby Shop 70 AJ SLICK 19 pagina's.
7
Insert the rudder onto the hinges and tail-wheel tiller wire as shown. Swing the rudder back and forth
several times to make sure it swings easily 45 degrees each way. Clean any glue which seeps out of the
hinges and allow to dry. If using polyurethane glue, you may see more glue seeping out as it dries. Wipe
this away with alcohol. Allow to dry.
Note about rudder servo: For virtually all setups, you will use a pull-pull cable rudder system.
The following instructions describe this. If you install a very heavy power system, however, you
can use a push-pull rudder system. Photos are included at the end of the manual.
Remove covering over the rudder control arms slots, as shown, on both sides of the rudder.