3D Hobby Shop Edge 540 조립 설명서 - 페이지 3

{카테고리_이름} 3D Hobby Shop Edge 540에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Hobby Shop Edge 540 17 페이지.

Covering Material –

Your airplane is covered in genuine Oracover covering material. If you ever need to purchase additional

covering, Ultracote brand covering is an exact match.

Removing covering –

Use a new sharp blade in your hobby knife when removing covering over the access holes in the

airplane. You can also use a hot soldering iron, or a "hot knife" to remove covering if desired. Note that

covering material cuts easily, but rapidly dulls knife blades. To achieve clean cuts, change the blade

often. Remove the covering over the access holes in the fuselage as shown:

emove covering for the horizontal stabilizer, and for the elevator servo – NOTE only remove covering

for the elevator servo on ONE side of the fuselage.