Cube GTC 추가 운영 지침 - 페이지 6

{카테고리_이름} Cube GTC에 대한 추가 운영 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Cube GTC 7 페이지. Additional instructions for cube carbon frame and (full-) carbon forks
Cube GTC에 대해서도 마찬가지입니다: 추가 지침 (13 페이지)

페이지 인쇄
Cube GTC 추가 운영 지침
10 |
SUPER HPC /HPC/GTC

9.0 Assembly Instructions

9.1 The MTB bike frame

Seat post assembly
For seat post assembly apply carbon assembly paste
(e.g. from Dynamix, Syntace, ...) to seat post and to the
Consider max. allowed seat post length (x)
inside of seat tube. It is not allowed to use standard
including min. insert length (y):
grease!
120 mm (y) at 400 mm (x)
120 mm (y) for adjustable seat post (e.g.
Consider torque on seat clamp and seat post!
RockShox Reverb) with max. 420mm (x)
Max. 6 Nm
110 mm (y) at 380 mm (x)
Apply torque gradually!
100 mm (y) at 350 mm (x)
Brake mount screw(s)
Max. 8 Nm
Rear derailleur mount screw
Max. 8 Nm
Bottom bracket
Use only suitable „Pressfit" bea-
rings. Special tools for assembly
and disassembly of "Pressfit"
bearings are necessary. Grease
is only allowed on frames with
alloy tube.
Head set assembly (integrated
/ semiintegrated) Special tools
for assembly and disassembly
of head set or head set cups are
necessary. Usage of grease is not
allowed!
Bottle cage assembly screws
Only M5 screws are allowed.
Max. 3Nm
Front derailleur mount screw
Band type
Max. 4Nm / Min. 3 Nm (apply gradually)
E-direct
Max. 7Nm / Min. 5 Nm (apply gradually)
Direct Mount
Max. 7Nm / Min. 5 Nm (apply gradually)

9.2 The racing bike frame

For seat post assembly apply carbon assembly paste
Seat post assembly
(e.g. from Dynamix, Syntace, ...) to seat post and to the
inside of seat tube. It is not allowed to use standard
Consider max. allowed seat post length
grease!
(x) including min. insert length (y):
100 mm (y) at 350 mm (x)
Consider torque on seat clamp and seat post!
80 mm (y) at 300 mm (x)
Max. 6 Nm
Apply torque gradually!
Brake mount screw
Max. 8 Nm
Rear derailleur mount screw
Max. 8 Nm
SUPER HPC /HPC/GTC
Head set assembly (integrated
/ semiintegrated) Special tools
for assembly and disassembly
of head set or head set cups are
necessary. Usage of grease is not
allowed!
Cable stop screws
Max. 1,5 Nm
Bottle cage assembly screws
Only M5 screws are allowed.
Max. 3 Nm
Brake mount screw
Max. 8 Nm
Front derailleur mount screw
Band type
Max. 4 Nm / Min. 3 Nm
(apply gradually)
Brazed-on type
Max. 4 Nm / Min. 3 Nm
(apply gradually)
Bottom bracket
Use only suitable „Pressfit" bea-
rings. Special tools for assembly
and disassembly of "Pressfit"
bearings are necessary. Grease
is only allowed on frames with
alloy tube.
| 11