3D Hobby Shop Velox VR-1 조립 설명서 - 페이지 10
{카테고리_이름} 3D Hobby Shop Velox VR-1에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Hobby Shop Velox VR-1 17 페이지.
페이지 인쇄10
Measure the position of the horizontal stabilizer, front-to-back relative to the wing spar tube and also side-
to-side. The horizontal stabilizer should also be pushed forward tightly into its slot in the fuselage.
When you are satisfied that the stabilizer is straight, use thin CA glue as shown to attach it. NOTE: We
do not remove any covering on the stabilizer. CA glue bonds to covering material very well.
Install the elevator half with the elevator joiner rod. Slide the elevator into the stabilizer, make sure it
flexes easily at least 45 degrees up and down, and glue with 2 large drops of thin CA on each hinge.