3D Hobby Shop Velox VR-1 조립 설명서 - 페이지 9

{카테고리_이름} 3D Hobby Shop Velox VR-1에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Hobby Shop Velox VR-1 17 페이지.

Install the tailwheel support bracket onto the fuselage with 2 small wood screws and install the tail wheel

and collar as shown. Be careful to make sure that the bracket does not cause drag on the rudder and

rudder servo. If necessary, you can open the hole in the bracket larger.

Locate the carbon wing spar tube and the horizontal stabilizer. Insert both into the fuselage. To help

align the horizontal stabilizer to the wing spar tube, it can be helpful to support the fuselage on equal-

height supports. In this case, we have used steel paint cans as shown.