3D Hobby Shop YAK55 조립 설명서 - 페이지 18

{카테고리_이름} 3D Hobby Shop YAK55에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Hobby Shop YAK55 19 페이지.

leading edge is pointing forward as shown.

-- Insert the nylon bolts into the holes and tighten until snug with a flat head screwdriver.

Cowling Detail

Another optional feature of this kit is the cowling detail that resembles the radial cooling vanes seen on the full scale

Yak-55. Note that the use of the plate does restrict some cooling air entering the cowling to cool the motor, ESC and

batteries. So depending on your climate you may need to open just a panel or two for cool climates, or for hot climates it

may be best to leave it off the plane for maximum cooling.

-- Cut out some cooling air holes from the cowling detail using a pair of scissors or a sharp hobby knife.

-- Center the cowling detail plate in the cowling and glue with CA by running a bead of medium or thick CA around the

inside edge of the cowling as shown. Allow to fully cure before continued handling of the cowling as the flexing of the

cowling can prevent good adhesion.