3D Hobby Shop YAK55 Montagehandleiding - Pagina 18

Blader online of download pdf Montagehandleiding voor {categorie_naam} 3D Hobby Shop YAK55. 3D Hobby Shop YAK55 19 pagina's.

leading edge is pointing forward as shown.

-- Insert the nylon bolts into the holes and tighten until snug with a flat head screwdriver.

Cowling Detail

Another optional feature of this kit is the cowling detail that resembles the radial cooling vanes seen on the full scale

Yak-55. Note that the use of the plate does restrict some cooling air entering the cowling to cool the motor, ESC and

batteries. So depending on your climate you may need to open just a panel or two for cool climates, or for hot climates it

may be best to leave it off the plane for maximum cooling.

-- Cut out some cooling air holes from the cowling detail using a pair of scissors or a sharp hobby knife.

-- Center the cowling detail plate in the cowling and glue with CA by running a bead of medium or thick CA around the

inside edge of the cowling as shown. Allow to fully cure before continued handling of the cowling as the flexing of the

cowling can prevent good adhesion.