CUBE in-a-box V4 Series 자세한 조립 지침 - 페이지 4
{카테고리_이름} CUBE in-a-box V4 Series에 대한 자세한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. CUBE in-a-box V4 Series 5 페이지.
페이지 인쇄
6
7
8
9
10
11
- 2 -
Slide panels 3 (24"W) and
panels 4 (36"W) on top of
the four rail panels already
there. Then finish up with
the last rail-panels mounted
with alu cap (see TIP 1).
Assemble the 2 wire-guides
and slide/adjust them into
posts where you will need
them, preferably under
work top level.
Check and assemble all
brackets and the cantilever.
Use big chromed-screws
here.
Adjust the brackets and
cantilever to the mark level
(dot) or at a 28-1/4 inches
high on each post.
Cantilever goes on post C,
brackets go on other posts.
Display brackets on corners
and on all end posts.
You just need to tighten the
big chromed-screw to make
it hold.
To attach the counter top
you would need first to
place the 2 round-brackets
on top of the panels, as well
as 2 brackets back to back
as shown on picture.