CUBE in-a-box V4 Series Detailed Assembly Instructions - Page 4
Browse online or download pdf Detailed Assembly Instructions for Indoor Furnishing CUBE in-a-box V4 Series. CUBE in-a-box V4 Series 5 pages.
Print Page
6
7
8
9
10
11
- 2 -
Slide panels 3 (24"W) and
panels 4 (36"W) on top of
the four rail panels already
there. Then finish up with
the last rail-panels mounted
with alu cap (see TIP 1).
Assemble the 2 wire-guides
and slide/adjust them into
posts where you will need
them, preferably under
work top level.
Check and assemble all
brackets and the cantilever.
Use big chromed-screws
here.
Adjust the brackets and
cantilever to the mark level
(dot) or at a 28-1/4 inches
high on each post.
Cantilever goes on post C,
brackets go on other posts.
Display brackets on corners
and on all end posts.
You just need to tighten the
big chromed-screw to make
it hold.
To attach the counter top
you would need first to
place the 2 round-brackets
on top of the panels, as well
as 2 brackets back to back
as shown on picture.