3D Hobby Shop 59" AJ Slick 설치 매뉴얼 - 페이지 17
{카테고리_이름} 3D Hobby Shop 59" AJ Slick에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Hobby Shop 59" AJ Slick 20 페이지.
페이지 인쇄17
The firewall of the Slick is arranged to allow the widest possible selection of motors to fit. Extra space has
been provided for long motors and long prop adaptors. For this reason, if your motor is compact, you will
need to supply spacers to extend the motor forward as shown. Attach the motor using the included
4mms screws and blind nuts, using loctite. Mount your ESC to the side of the motor-mounting box.
The cowl is mounted onto the fuselage with 4 wood screws. These screws go into the small plywood
squares on the front inside of the fuselage. Soak these squares in thin CA glue to harden them before
proceeding.
The following procedure is helpful to be sure the wood screws hit the plywood squares.
First, make small holes into the plywood squares through the covering, with the cowl and canopy off.
Tape small pieces of paper over these holes, as shown, and mark the hole locations on these pieces of
paper.