3D Hobby Shop 59" AJ Slick 설치 매뉴얼 - 페이지 9

{카테고리_이름} 3D Hobby Shop 59" AJ Slick에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Hobby Shop 59" AJ Slick 20 페이지.

Install the elevator half with the fiberglass joiner rod onto the stabilizer. Makes sure it flexes easily at

least 45 degrees up and 45 degrees down, and has approx 1/32" of gap in the hingeline. Apply thin CA

glue to the hinges, 2 large drops on each.

Place a piece of removable tape on the elevator counterbalance as shown. This will hold the right side

elevator in perfect alignment with the horizontal stab. Install the other side elevator without glue and look

at its alignment. Make sure you can align both elevators, sand the elevator joiner slot in the elevator if

necessary. Make sure you are happy with the alignment of the elevators.