Dish Network Duo ViP 222 원격 제어 설정 - 페이지 10

{카테고리_이름} Dish Network Duo ViP 222에 대한 원격 제어 설정을 온라인으로 검색하거나 PDF를 다운로드하세요. Dish Network Duo ViP 222 17 페이지. Dish network remote control setup guide
Dish Network Duo ViP 222에 대해서도 마찬가지입니다: 시작하기 (2 페이지), 시작하기 (2 페이지)

페이지 인쇄

222.book Page 66 Tuesday, July 25, 2006 1:30 PM

Chapter 9

Controlling Other Components

For AUX mode: The first group of

flashes tells you what the AUX mode

controls. A quick flash (zero) before the

three-digit code is for a TV; one regular

flash is for a VCR; and two flashes is

for a tuner, or amplifier.

For a satellite receiver programmed in

AUX mode: The AUX mode button will

flash the same number of times as the

address number.

For Limited Mode: If you have

programmed a TV or VCR in Limited

Mode, the mode button flashes once at

the end of the flash sequence.

Controlling a Tuner/Amplifier

Use the following remote control buttons to control a tuner or amplifier. When the remote

control is set up as described on pages 61 and 67, press the AUX mode button to set the

remote to AUX mode. The AUX mode button will stay lit for two seconds to show you've

set the remote to AUX mode. Make sure to keep the remote in AUX mode to use the

following buttons.

Instructions

Additional Information

For example, if the TV code is 570, the AUX

mode button flashes once quickly (indicating 0

for TV), pauses, flashes five times, pauses,

flashes seven times, pauses, and flashes once

quickly.

For example, if the receiver address is 3, the

AUX mode button flashes three times.

For example, if the TV code is 570, the AUX

mode button flashes once quickly (indicating 0

for TV), pauses, flashes five times, pauses,

flashes seven times, pauses, flashes once

quickly, and then flashes once (indicting

Limited Mode).