Dish Network Duo ViP 222 원격 제어 설정 - 페이지 12

{카테고리_이름} Dish Network Duo ViP 222에 대한 원격 제어 설정을 온라인으로 검색하거나 PDF를 다운로드하세요. Dish Network Duo ViP 222 17 페이지. Dish network remote control setup guide
Dish Network Duo ViP 222에 대해서도 마찬가지입니다: 시작하기 (2 페이지), 시작하기 (2 페이지)

페이지 인쇄

222.book Page 68 Tuesday, July 25, 2006 1:30 PM

Chapter 9

The Recover Button

Turn on the other receiver and display the System Info screen as described in the user's

guide for information on how to display the screen).

Write the address:

Press and hold AUX until all the other mode buttons light up, and then let go of the button.

AUX flashes.

Press the 3 button.

Use the NUMBER PAD to enter the address you wrote in step 1.

Press POUND (#). AUX blinks three times.

Press RECORD to make sure the address in the remote matches the address on the

receiver.

ECOVER

Use RECOVER if you suddenly have a snowy, blue, or black screen on your TV and

cannot get the picture back from your satellite receiver. When you press RECOVER as

described below, the remote control sends commands to your TV to change channels or

video inputs to get back to watching satellite programming. This procedure works only if

you have accidentally changed the TV channel or video input. It does not recover lost

satellite signal (See Troubleshooting on page 104 for information on solving problems).

Note: The remote must be programmed to control the TV (and VCR, if applicable) for

RECOVER to work as described.

Note: RECOVER will first try to tune your TV to channel 3, then channel 4, and then other

video inputs with each press of RECOVER. You may need to press RECOVER up to 30

times to recover your satellite TV video. If RECOVER is programmed to a specific channel

(see page 69), RECOVER will tune the TV to the specific channel (for example, channel

60).

UTTON