Dish Network Duo ViP 222 원격 제어 설정 - 페이지 13

{카테고리_이름} Dish Network Duo ViP 222에 대한 원격 제어 설정을 온라인으로 검색하거나 PDF를 다운로드하세요. Dish Network Duo ViP 222 17 페이지. Dish network remote control setup guide
Dish Network Duo ViP 222에 대해서도 마찬가지입니다: 시작하기 (2 페이지), 시작하기 (2 페이지)

페이지 인쇄

222.book Page 69 Tuesday, July 25, 2006 1:30 PM

Programming the Recover Button for Remote Control 2

When your Remote Control 2 is shipped from the factory, RECOVER is set up to restore

satellite TV viewing by tuning your TV (or VCR) to channel 3, 4, and other inputs.

However, to use RECOVER with your remote TV (or VCR), you need to program

RECOVER with the specific channel (for example, channel 60) that you use to watch TV2

programming. The following instructions describe how to program RECOVER to tune your

remote TV (or VCR) back to a selected channel.

Using the Recover Button

The following setup is required to use RECOVER:

•

Note: Press any remote control button other than RECOVER to end this procedure.

Note: If RECOVER is not programmed to a specific channel, RECOVER will first try to

tune your TV to channel 3, then channel 4, and then other video inputs with each press of

RECOVER. You may need to press RECOVER up to 30 times to recover your satellite TV

video. If RECOVER is programmed to a specific channel (see page 69), RECOVER will

tune the TV to the specific channel (for example, channel 60).

The remote control must be set up to control the TV and, if installed, the VCR.

If a VCR is installed, make sure it is connected as shown on page 94.

On a remote TV, RECOVER must be programmed to tune your remote TV to the spe-

cific channel to receive TV2 programming (for example, channel 60), using the

instructions on page 69.

Remote Controls

The Recover Button