CubuSynth VCFA 빌드 매뉴얼 - 페이지 12
{카테고리_이름} CubuSynth VCFA에 대한 빌드 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CubuSynth VCFA 14 페이지. Multimode vcf with lp,hp and bp outputs and integrated vca
CubuSynth VCFA에 대해서도 마찬가지입니다: 매뉴얼 (5 페이지)
페이지 인쇄CubuSynth VCFA - Build Guide
STEP 14
Installing ICs and final check
3
2
Take the Main PCB and install the Ics. Make sure to install
the chips in their specific spot. Bend the Legs of the Ics
inwards a bit so they form a 90° degree angle to the body of
the chip. Make sure the orientation is correct, the notch has
to match the silkscreen / the sockets placed before.
Check your soldering. If you see shorts or bad solder joints,
fix it up. Then check the power pins for shorts with your
multimeter.
When everything looks fine, you can fit the control PCB, so
the Pin headers are connected properly. Then tighten the
Screws on the Main PCB to the standoffs.
Page 12
TL074
U1,U4,U5
LM13700N
U3,U2
PCB V1.2 Sept 2022