Dish Network DISH Player-DVR 522 원격 제어 설정 - 페이지 5
{카테고리_이름} Dish Network DISH Player-DVR 522에 대한 원격 제어 설정을 온라인으로 검색하거나 PDF를 다운로드하세요. Dish Network DISH Player-DVR 522 17 페이지. Dish network remote control setup guide
Dish Network DISH Player-DVR 522에 대해서도 마찬가지입니다: 사용자 설명서 (1 페이지), 시작하기 (2 페이지)
페이지 인쇄
222.book Page 61 Tuesday, July 25, 2006 1:30 PM
Installing a UHF Attenuator
Unwanted UHF signals may interfere with signals from the remote control to the receiver.
To prevent such interference, you can install a 10 dB attenuator (available from many
consumer electronics parts stores). Adding this attenuator will help keep out stray UHF
signals, but it also cut down how far away you can use the remote control.
1
2
3
C
ONTROLLING
To use the remote to control other devices (such as a TV, VCR, DVD player, tuner,
amplifier, or DISH Network satellite receiver), you must first program it to control these
other devices. You can do this by either following the instructions in Setting Up Using
Device Code Tables on page 63, or the Setting Up Using Device Codes Scan procedure
described on page 64.
Remove the UHF antenna from the UHF Remote
Antenna input on the receiver back panel.
Attach a 10 dB attenuator to the UHF Remote
Antenna input.
Attach the UHF antenna to the attenuator.
O
C
THER
OMPONENTS
Remote Controls
Controlling Other Components
61