Dish Network DISH Player-DVR 522 원격 제어 설정 - 페이지 9
{카테고리_이름} Dish Network DISH Player-DVR 522에 대한 원격 제어 설정을 온라인으로 검색하거나 PDF를 다운로드하세요. Dish Network DISH Player-DVR 522 17 페이지. Dish network remote control setup guide
Dish Network DISH Player-DVR 522에 대해서도 마찬가지입니다: 사용자 설명서 (1 페이지), 시작하기 (2 페이지)
페이지 인쇄
222.book Page 65 Tuesday, July 25, 2006 1:30 PM
5
Press the UP or DOWN ARROW
repeatedly until the device turns off.
6
Press POUND (#).
7
Turn the device back on and try some
other buttons to make sure they work.
8
If necessary, repeat this procedure until
you've tried all the codes.
Checking the Device Codes
You can find out what device code you've set for each remote control mode (TV, VCR, and
AUX)
1
Press and hold the appropriate mode
button until all the other mode buttons
light up, and then let go of the button.
The mode button flashes.
2
Press the Pound (#) button twice.
Watch the mode light to determine your
code. The mode button flashes the
number for each digit of the device
code, with a pause between the groups
of flashes. A quick flash is for zero.
Instructions
.
Instructions
Remote Controls
Controlling Other Components
Additional Information
As you press the UP or DOWN ARROW, the
remote tries each code in the memory to see if
it can turn off your device. When the device
turns off, you have found a code that might
work.
Note: The mode button for the device will flash
rapidly eight times when you've scanned all the
codes for that device.
The mode button flashes three times if you
have entered the code correctly. This stores the
code you found.
Try some other buttons to make sure they
work. Sometimes POWER works when other
buttons don't. If using Limited Mode, try
VOLUME or MUTE.
You may need to repeat the scan to find the
best code for your device.
Additional Information
For example, hold TV for a TV until all of the
other mode buttons light. When you let go, TV
will flash.
For example, if the code is 570, the mode
button flashes five times, pauses, flashes
seven times, pauses, and flashes once quickly.
65