Dish Network ViP 211 Series 설정 지침 - 페이지 2
{카테고리_이름} Dish Network ViP 211 Series에 대한 설정 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Dish Network ViP 211 Series 2 페이지. Quick facts; quick remote control programming & tips for installers
Dish Network ViP 211 Series에 대해서도 마찬가지입니다: 사용자 지정 매뉴얼 (10 페이지), 빠른 참조 매뉴얼 (2 페이지), 시작하기 (2 페이지), 매뉴얼 (2 페이지)
페이지 인쇄
8
With all information entered, an azimuth angle and elevation angle will be displayed under the zip code. Record these angles.
Now, follow the steps in the MP1 user guide to point the dish using the azimuth and elevation angles. Return to step 9 of
receiver setup after successfully pointing the dish.
9
and that the satellite displayed is the desired satellite. If the
bar is RED, but showing Signal Strength, that means you are
pointed at the wrong satellite and you need to adjust the dish.
Winegard is a registered trademark and MP1 is a trademark of Winegard Company.
Input zip code of current location and dish type. Zip Code should be the zip code of
your current location. Note that whenever you move the satellite antenna to a new
location, you must enter the zip code of your new current location.
On the display, Dish System should always be Dish 300. The satellite should be
whatever satellite you want to point at. Satellite 119 is the primary satellite, and the
majority of programming is located here. Use Transponder 11 for Satellite 119.
*If using a 311 or previous model receiver, select Peak Angles to enter your satellite
and zip code.
Once accurately
pointed, the
signal meter will
turn green. Make
small adjustments
to get the signal
as high as
possible. Check
that the bar at
the bottom of the
screen is green
DISH and ViP are registered trademarks of DISH Network L.L.C.
10
Continue to Cancel
out of the menus.
Once out of the menu,
the Progress will start
counting up until
5 of 5. A program
guide may download,
which you can stop at
anytime.