Dishlex DX103 사용자 설명서 - 페이지 12

{카테고리_이름} Dishlex DX103에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dishlex DX103 16 페이지. Freestanding dishwasher
Dishlex DX103에 대해서도 마찬가지입니다: 사용자 설명서 (16 페이지), 설치 매뉴얼 (3 페이지)

페이지 인쇄

Adjusting the level of the appliance

Make sure that the appliance is level to close and seal

the door correctly. If the level of the appliance is correct,

Water connection

Water inlet hose

Connect the appliance to a cold water supply.

Connect the inlet hose to a water tap with an external

BSP thread spout of 3/4".

Inlet water supply

• Cold water pressure: 800 kPa max - 50 kPa min.

• Water flow rate 10 L / minute min.

• If cold water pressure is in excess of 800 kPa, a

pressure reducing valve should be used. Check for

leaks.

Caution! Always use new hoses when you

connect the appliance to the water mains. Old

hoses must not be used. The water inlet hose must be

examined at an interval of twelve months for

deterioration and replaced if necessary.

The water pressure must be in the limits (refer to 'Tech-

nical data'). Make sure that the local water authority

gives you the average mains pressure in your area.

Make sure that there are no kinks in the water inlet hose

and that the water inlet hose is not squashed or entan-

gled.

the door does not catch on the sides of the cabinet. If

the door does not close correctly, loosen or tighten the

adjustable feet until the appliance is level.

Adhesive steam protection foil

If the worktop is removed, fit the steam protection onto

the front part of the kitchen cabinet benchtop.

The steam protection foil is not supplied with free-

standing models, but can be purchased from

Electrolux Spare Parts.

Fit the hose nut correctly to prevent water leaks.

Caution! Do not connect the appliance to new

pipes or pipes that have been not used for a long

time. Let the water run for some minutes, then connect

the inlet hose.

Water drain hose

The highest point of the drain hose must be no more

than 60 cm from the floor and must have a continuous

fall.

The drain hose can be lengthened using additional

lengths and connectors. These must be purchased

from Electrolux Spare Parts. The extension length must

not exceed 2 metres.

The drain hose must be free of kinks and obstructions.

Remove the sink plug when the appliance drains the

water to prevent that the water goes back into the ap-

pliance.

If you connect the water drain hose to a trap spigot

under the sink, remove the plastic membrane. If you do

not remove the membrane, remaining food can cause

a blockage in the drain hose spigot.