3D Robotics IRIS 매뉴얼 - 페이지 2
{카테고리_이름} 3D Robotics IRIS에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Robotics IRIS 5 페이지. Tarot gimbal
페이지 인쇄3
Add the nut to the bolt, and tighten to secure the leg to the arm.
Attach all four tall legs to IRIS.
assembled leg
2 Attach camera
Your Tarot gimbal is compatible with a GoPro HERO3, available from store.3dr.com.
Important note: Make sure that the WiFi on your GoPro is
!
turned OFF at all times when in use with IRIS.
1
Remove the two screws securing the blue face plate.
Remove the plate, and loosen the set screw.
remove
2
Slide camera into housing with the lens nearest
the top-right corner.
loosen
Optional: To remove the short legs, use
the small hex key (1.5 mm) to remove the
screw in the bottom of the leg, and slide
the leg out of the arm.
remove
face plate