Diskashur PRO 140-2 사용자 설명서 - 페이지 7
{카테고리_이름} Diskashur PRO 140-2에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Diskashur PRO 140-2 19 페이지.
페이지 인쇄diskAshur PRO Keypad Panel
PRO
First Time Use
Before diskAshur PRO can be used, the Admin PIN MUST be set. The LED will display
Solid
BLUE
and Solid
To Set-up the Admin PIN:
1.
Press UNLOCK + 9. The LED will change to Solid
2.
Enter the new Admin PIN and press UNLOCK key. If accepted the
will flash for 3 short blinks, then return to Solid
3.
Re-enter the Admin PIN and press the UNLOCK key. If accepted the
LED will be Solid for 3 seconds.
4.
LED will then turn
LOCK key is pressed, will return the drive to a standby state.
5.
The Admin PIN is now set and will allow access to the drive or the Admin features.
6.
To UNLOCK the drive, exit Admin by pressing the LOCK button. Then enter the
new PIN and press UNLOCK.
Requirements for Admin, User and Self-Destruct PIN:
PINs must be a minimum length of 7 maximum 16 digits.
Cannot contain all consecutive numbers (2345678 or 9876543)
Cannot contain all same number (1111111)
The SHIFT key can be used for additional combinations.
SHIFT + 1 are a separate value than just 1.
TM
®
GREEN
to indicate diskAshur PRO is waiting for a PIN to be set.
BLUE
and remain in Admin mode for 30 seconds or if the
1
2
3
4
4
LED Indicator lights
When you first plug in the FIPS
3
diskAshur PRO drive, the unit will
do a self-test to verify all security
components are working properly.
2
The LEDs will go through 3 test
stages RED, GREEN, and BLUE.
This will be followed by three
1
GREEN
test. Any test failure will leave the
unit in an interoperable state with
the
RED
BLUE
BLUE
and Blinking GREEN.
SHIFT button
UNLOCK button
LOCK button
flashes on a successful
LED flashing.
and Blinking GREEN.
GREEN
GREEN
LED
7