Diskashur PRO 140-2 사용자 설명서 - 페이지 8

{카테고리_이름} Diskashur PRO 140-2에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Diskashur PRO 140-2 19 페이지.

Locking the Drive

To lock the drive, press the LOCK button.

If data is still being written to the drive, diskAshur PRO will wait until all data has been written

to the drive and then it will lock automatically.

Note: The diskAshur PRO will not be recognized by the operating system in the standby state.

To unlock the drive:

Enter either a User PIN or Admin PIN and press the UNLOCK button.

Note: The diskAshur PRO cannot be recognized by the operating system in the standby state.

To enter the Admin Mode, do the following:

Attach the USB cable to an available USB port on your computer. The diskAshur PRO

goes into the Standby Mode after the self-check, and the LED turns RED.

Press and hold UNLOCK + 0 for five seconds until the LED flashes RED.

This indicates that you can enter the Admin PIN.

Enter the Admin PIN and press the UNLOCK button.

The drive is in Admin Mode when the LED has changed to BLUE.

You can change the Admin PIN by doing the following:

Enter Admin Mode (UNLOCK + 0 for five seconds. Enter Admin PIN and press UNLOCK).

Press and hold UNLOCK + 9 until the LED turns to Solid

Enter the new PIN and press UNLOCK (The PIN must be a minimum of 7 digits and a

maximum of 16 digits). The LED flashes

and Blinking GREEN.

Re-enter the new Admin PIN and press UNLOCK. The LED stays solid

two seconds and then solid

successfully.

GREEN

BLUE

indicating that the Admin PIN has been changed

BLUE

and Blinking GREEN.

three times, then returns to Solid

BLUE

GREEN

for