3D Systems CUBE 사용자 설명서 - 페이지 9

{카테고리_이름} 3D Systems CUBE에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Systems CUBE 20 페이지. Replacing the print tip
3D Systems CUBE에 대해서도 마찬가지입니다: 문서 (8 페이지), 레슨 (15 페이지)

페이지 인쇄

Purging is not always required but is recommended after performing a long print.

This will ensure that both jets are clear and ready for the next print. Purge the PLA

print jet and then purge the INF print jet before printing a new part.

Position The Part To Optimize The Print

For best results, position PLA parts in a way where there are fewer horizontal spans

between vertical features.

Preferred

Note the horizontal features of this part. Even though the bars in this part span a

signiﬁcant distance, these features will be properly supported by INF material.

Not Preferred

Note the vertical features of the part in this illustration. Spanning PLA material

between multiple vertical features may not print as intended.

Maintain Larger Footprints

Arrange the part where you will have the largest footprint touching the print pad.