3D Systems CUBE 사용자 설명서 - 페이지 11

{카테고리_이름} 3D Systems CUBE에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Systems CUBE 20 페이지. Replacing the print tip
3D Systems CUBE에 대해서도 마찬가지입니다: 문서 (8 페이지), 레슨 (15 페이지)

페이지 인쇄
3D Systems CUBE 사용자 설명서
Level The Nozzles
If PLA and INF material do not adhere to one another, check the nozzle level. Print
the nozzle level test file and adjust as needed.
NOTE: Auto Level should always be performed before the Auto Gap
procedure.
NOTE: Auto Level should be performed when the printer is positioned away
from bright lights or direct sunlight.
Auto Level
1.
Navigate to the Print Plate Calibration screen and select
2.
Clean the print pad thoroughly removing all glue and debris. Select the
continue.
NOTE: The surface of the print pad must be completely clean.
AUTO
LEVEL.
checkmark
to