3D Systems CubePro 원본 사용 설명서 - 페이지 16

{카테고리_이름} 3D Systems CubePro에 대한 원본 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Systems CubePro 18 페이지. Unjamming extruder
3D Systems CubePro에 대해서도 마찬가지입니다: 매뉴얼 (11 페이지), 원본 사용 설명서 (12 페이지)

페이지 인쇄

27. Insert the original nine (9) screws that were removed in step 5 and

secure the inner floor to the standoffs using a 3 mm hex head driver.

28. Place the heater onto the standoffs and insert the four (4) 2.5 mm hex

head screws. Using a 2.5 mm hex head driver, secure the heater to the

standoffs.

29. Connect the power cord to the printer and turn on the main power

switch. Turn on the touchscreen display.

30. Install the jet wiper assembly.

31. Install the material cartridges. Refer to the user guide for more

information.

32. Once the material cartridges have been installed, navigate to the

Materials screen and select CARTRIDGE STATUS. Verify that the

installed cartridges are recognized by the printer.

3D Systems, Inc.