3D Systems CubePro 원본 사용 설명서 - 페이지 15

{카테고리_이름} 3D Systems CubePro에 대한 원본 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Systems CubePro 18 페이지. Unjamming extruder
3D Systems CubePro에 대해서도 마찬가지입니다: 매뉴얼 (11 페이지), 원본 사용 설명서 (12 페이지)

페이지 인쇄

22. Route the delivery tube nuts through the holes in the inner floor and

position them where they will be secured.

23. Using zip ties, secure the delivery tube nuts to the inner floor. Cut off

any excess plastic from the zip ties.

CAUTION: Remove all remnants of the wire ties. Any plastic

that may drop into the components can cause damage if left

there.

24. Reconnect the material cartridge bay sensors.

25. Maneuver the interior heater and position it above the inner floor.

26. Lower the inner floor and align the screw holes with the standoffs

underneath.

3D Systems, Inc.

Front

Bottom