3D Systems CubePro Manual de instrucciones original - Página 15
Navegue en línea o descargue pdf Manual de instrucciones original para Impresoras 3D 3D Systems CubePro. 3D Systems CubePro 18 páginas. Unjamming extruder
También para 3D Systems CubePro: Manual (11 páginas), Manual de instrucciones original (12 páginas)
Imprimir página
22. Route the delivery tube nuts through the holes in the inner floor and
position them where they will be secured.
23. Using zip ties, secure the delivery tube nuts to the inner floor. Cut off
any excess plastic from the zip ties.
CAUTION: Remove all remnants of the wire ties. Any plastic
that may drop into the components can cause damage if left
there.
24. Reconnect the material cartridge bay sensors.
25. Maneuver the interior heater and position it above the inner floor.
26. Lower the inner floor and align the screw holes with the standoffs
underneath.
3D Systems, Inc.
14
Front
Bottom