3D Systems CubePro Manual Petunjuk Asli - Halaman 15

Jelajahi secara online atau unduh pdf Manual Petunjuk Asli untuk Printer 3D 3D Systems CubePro. 3D Systems CubePro 18 halaman. Unjamming extruder
Juga untuk 3D Systems CubePro: Manual (11 halaman), Manual Petunjuk Asli (12 halaman)

Halaman Cetak

22. Route the delivery tube nuts through the holes in the inner floor and

position them where they will be secured.

23. Using zip ties, secure the delivery tube nuts to the inner floor. Cut off

any excess plastic from the zip ties.

CAUTION: Remove all remnants of the wire ties. Any plastic

that may drop into the components can cause damage if left

there.

24. Reconnect the material cartridge bay sensors.

25. Maneuver the interior heater and position it above the inner floor.

26. Lower the inner floor and align the screw holes with the standoffs

underneath.

3D Systems, Inc.

Front

Bottom