3D Systems CubePro Manual

Jelajahi secara online atau unduh pdf Manual untuk Printer 3D 3D Systems CubePro. 3D Systems CubePro 11 halaman. Unjamming extruder
Juga untuk 3D Systems CubePro: Manual Petunjuk Asli (18 halaman), Manual Petunjuk Asli (12 halaman)

Halaman Cetak
3D Systems CubePro Manual
UNJAMMING A CUBEPRO EXTRUDER
 Tools required:
o 2.5 mm Hex screwdriver
o T10 Torx driver
o Pliers
o Side cutters
 First, switch the power off. Turn machine 180 degrees, so the back panel faces you.
 Remove the top lid, then disconnect the sensor loom from the sensor PCB
 Disconnect sensor loom from breakout board