3D Systems CubePro Manual

Browse online or download pdf Manual for 3D Printers 3D Systems CubePro. 3D Systems CubePro 11 pages. Unjamming extruder
Also for 3D Systems CubePro: Original Instructions Manual (18 pages), Original Instructions Manual (12 pages)

Print Page
3D Systems CubePro Manual
UNJAMMING A CUBEPRO EXTRUDER
 Tools required:
o 2.5 mm Hex screwdriver
o T10 Torx driver
o Pliers
o Side cutters
 First, switch the power off. Turn machine 180 degrees, so the back panel faces you.
 Remove the top lid, then disconnect the sensor loom from the sensor PCB
 Disconnect sensor loom from breakout board