3D Systems CubePro Manual - Page 6
Browse online or download pdf Manual for 3D Printers 3D Systems CubePro. 3D Systems CubePro 11 pages. Unjamming extruder
Also for 3D Systems CubePro: Original Instructions Manual (18 pages), Original Instructions Manual (12 pages)
Print Page
Using flat pliers provided with the toolbox, remove the idler wheel assembly from extruder
drive assembly. Pull very carefully pinching on the end of idler wheel, being careful not to
touch or damage the sensor disk or sensor sticker.
1.
Loosen both bolts holding the breakout board using the 2.5 mm Hex driver
4.