3D Systems CubePro Manual - Página 6
Procurar online ou descarregar pdf Manual para Impressoras 3D 3D Systems CubePro. 3D Systems CubePro 11 páginas. Unjamming extruder
Também para 3D Systems CubePro: Manual de instruções original (18 páginas), Manual de instruções original (12 páginas)
Imprimir página
Using flat pliers provided with the toolbox, remove the idler wheel assembly from extruder
drive assembly. Pull very carefully pinching on the end of idler wheel, being careful not to
touch or damage the sensor disk or sensor sticker.
1.
Loosen both bolts holding the breakout board using the 2.5 mm Hex driver
4.