3D Systems CubePro Manual - Halaman 6
Jelajahi secara online atau unduh pdf Manual untuk Printer 3D 3D Systems CubePro. 3D Systems CubePro 11 halaman. Unjamming extruder
Juga untuk 3D Systems CubePro: Manual Petunjuk Asli (18 halaman), Manual Petunjuk Asli (12 halaman)
Halaman Cetak
Using flat pliers provided with the toolbox, remove the idler wheel assembly from extruder
drive assembly. Pull very carefully pinching on the end of idler wheel, being careful not to
touch or damage the sensor disk or sensor sticker.
1.
Loosen both bolts holding the breakout board using the 2.5 mm Hex driver
4.