3D Systems CubePro Manual

Navegue en línea o descargue pdf Manual para Impresoras 3D 3D Systems CubePro. 3D Systems CubePro 11 páginas. Unjamming extruder
También para 3D Systems CubePro: Manual de instrucciones original (18 páginas), Manual de instrucciones original (12 páginas)

Imprimir página
3D Systems CubePro Manual
UNJAMMING A CUBEPRO EXTRUDER
 Tools required:
o 2.5 mm Hex screwdriver
o T10 Torx driver
o Pliers
o Side cutters
 First, switch the power off. Turn machine 180 degrees, so the back panel faces you.
 Remove the top lid, then disconnect the sensor loom from the sensor PCB
 Disconnect sensor loom from breakout board