3D Systems CubePro Manual Petunjuk Asli - Halaman 14

Jelajahi secara online atau unduh pdf Manual Petunjuk Asli untuk Printer 3D 3D Systems CubePro. 3D Systems CubePro 18 halaman. Unjamming extruder
Juga untuk 3D Systems CubePro: Manual (11 halaman), Manual Petunjuk Asli (12 halaman)

Halaman Cetak

19. Place cartridge bay2 on top of the inner floor. Insert the four (4) 2.5

mm hex head screws through the lower hinges and the inner floor and

attach the four 7 mm nuts. Tighten the nuts.

NOTE: Proceed to step 21 if no other parts are being

replaced.

20. Secure the cartridge sensor assembly to the bottom of cartridge bay 2

by inserting and tightening both (2) 2.5 mm hex head screws.

CAUTION: Do not over-tighten the screws. Over-tightening

the screws could damage the cartridge sensor and void the

manufacturer's warranty.

21. Carefully tilt the inner floor at an angle and place it into the printer.

CAUTION: As you rotate the inner floor horizontally, make

note of the position of the interior heater assembly.

3D Systems, Inc.

Bottom of Inner Floor