3D Systems CubePro Manual Petunjuk Asli - Halaman 13

Jelajahi secara online atau unduh pdf Manual Petunjuk Asli untuk Printer 3D 3D Systems CubePro. 3D Systems CubePro 18 halaman. Unjamming extruder
Juga untuk 3D Systems CubePro: Manual (11 halaman), Manual Petunjuk Asli (12 halaman)

Halaman Cetak

16. Insert both (2) 2.5 mm hex head screws through the cartridge sensor

and cartridge sensor shim. Secure the screws through the inner floor,

to the cartridge bay.

CAUTION: Do not over-tighten the screws. Over-tightening

the screws could damage the cartridge sensor and void the

manufacturer's warranty.

NOTE: Proceed to step 21 if no other parts are being

replaced.

17. To replace cartridge bay 2 PCB, loosen and remove both 2.5 mm hex

head screws securing the cartridge bay sensor assembly to cartridge

bay 2.

NOTE: To install cartridge bay 2 PCB, proceed to step 20.

18. To replace cartridge bay 2, loosen and remove the four (4) 2.5 mm hex

head cap screws (A) and 7 mm nuts (B) securing the lower hinge of

cartridge 2 to the inner floor.

3D Systems, Inc.

Bottom of Inner Floor