3D Systems CubePro Manual Petunjuk Asli - Halaman 11

Jelajahi secara online atau unduh pdf Manual Petunjuk Asli untuk Printer 3D 3D Systems CubePro. 3D Systems CubePro 18 halaman. Unjamming extruder
Juga untuk 3D Systems CubePro: Manual (11 halaman), Manual Petunjuk Asli (12 halaman)

Halaman Cetak

10. Using wire cutters, carefully cut the six (6) zip ties securing the delivery

tube nuts to the inner floor.

CAUTION: Remove all remnants of the wire ties. Any plastic

that may drop into the components can cause damage if left

there.

11. Route the delivery tube nuts to the rounded openings in the inner floor

and push them through.

12. Carefully tilt the inner floor at an angle and pull it out of the printer.

CAUTION: Ensure the heater assembly is properly supported

as you tilt the floor. Place the heater assembly on the printer

outer floor away from other components.

3D Systems, Inc.

Front

Bottom

Top