3D Systems CubePro 원본 사용 설명서 - 페이지 11

{카테고리_이름} 3D Systems CubePro에 대한 원본 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Systems CubePro 18 페이지. Unjamming extruder
3D Systems CubePro에 대해서도 마찬가지입니다: 매뉴얼 (11 페이지), 원본 사용 설명서 (12 페이지)

페이지 인쇄

10. Using wire cutters, carefully cut the six (6) zip ties securing the delivery

tube nuts to the inner floor.

CAUTION: Remove all remnants of the wire ties. Any plastic

that may drop into the components can cause damage if left

there.

11. Route the delivery tube nuts to the rounded openings in the inner floor

and push them through.

12. Carefully tilt the inner floor at an angle and pull it out of the printer.

CAUTION: Ensure the heater assembly is properly supported

as you tilt the floor. Place the heater assembly on the printer

outer floor away from other components.

3D Systems, Inc.

Front

Bottom

Top