3D Systems CubePro 원본 사용 설명서 - 페이지 12

{카테고리_이름} 3D Systems CubePro에 대한 원본 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Systems CubePro 18 페이지. Unjamming extruder
3D Systems CubePro에 대해서도 마찬가지입니다: 매뉴얼 (11 페이지), 원본 사용 설명서 (12 페이지)

페이지 인쇄

13. To replace cartridge bay 1 PCB only, loosen and remove both 2.5 mm

hex head screws securing the cartridge bay PCB assembly to cartridge

bay 1. Proceed to step 16.

NOTE: The same steps for replacing cartridge bay 1 PCB

can be applied to replacing cartridge bay 3 PCB.

NOTE: For replacement of cartridge bay 2 PCB, proceed to

step 17.

NOTE: For replacement of cartridge bay 2, proceed to step

18.

14. Using a 3 mm hex driver and an 8 mm wrench, loosen and remove

all three (3) 3 mm hex head screws (A) and 8 mm nuts (B) securing

cartridge bay 1 to the inner floor. Remove cartridge bay 1. Retain all

hardware for reinstallation.

15. Insert the three (3) 3 mm hex head screws (A) through the cartridge

bay and then through the inner floor.

CAUTION: Do not over-tighten the screws. Over-tightening

the screws could damage the inner floor and void the

manufacturer's warranty.

3D Systems, Inc.

Back Left

Back Left View