3D Systems CubePro Manuel d'instructions original - Page 12
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions original pour {nom_de_la_catégorie} 3D Systems CubePro. 3D Systems CubePro 18 pages. Unjamming extruder
Également pour 3D Systems CubePro : Manuel (11 pages), Manuel d'instructions original (12 pages)
Imprimer la page
13. To replace cartridge bay 1 PCB only, loosen and remove both 2.5 mm
hex head screws securing the cartridge bay PCB assembly to cartridge
bay 1. Proceed to step 16.
NOTE: The same steps for replacing cartridge bay 1 PCB
can be applied to replacing cartridge bay 3 PCB.
NOTE: For replacement of cartridge bay 2 PCB, proceed to
step 17.
NOTE: For replacement of cartridge bay 2, proceed to step
18.
14. Using a 3 mm hex driver and an 8 mm wrench, loosen and remove
all three (3) 3 mm hex head screws (A) and 8 mm nuts (B) securing
cartridge bay 1 to the inner floor. Remove cartridge bay 1. Retain all
hardware for reinstallation.
15. Insert the three (3) 3 mm hex head screws (A) through the cartridge
bay and then through the inner floor.
CAUTION: Do not over-tighten the screws. Over-tightening
the screws could damage the inner floor and void the
manufacturer's warranty.
3D Systems, Inc.
Back Left
A
Back Left View
A
11