- ページ 12

3Dプリンター 3D Systems CubeProのPDF オリジナル取扱説明書をオンラインで閲覧またはダウンロードできます。3D Systems CubePro 18 ページ。 Unjamming extruder
3D Systems CubePro にも：マニュアル (11 ページ), オリジナル取扱説明書 (12 ページ)

ページを印刷する

13. To replace cartridge bay 1 PCB only, loosen and remove both 2.5 mm

hex head screws securing the cartridge bay PCB assembly to cartridge

bay 1. Proceed to step 16.

NOTE: The same steps for replacing cartridge bay 1 PCB

can be applied to replacing cartridge bay 3 PCB.

NOTE: For replacement of cartridge bay 2 PCB, proceed to

step 17.

NOTE: For replacement of cartridge bay 2, proceed to step

18.

14. Using a 3 mm hex driver and an 8 mm wrench, loosen and remove

all three (3) 3 mm hex head screws (A) and 8 mm nuts (B) securing

cartridge bay 1 to the inner floor. Remove cartridge bay 1. Retain all

hardware for reinstallation.

15. Insert the three (3) 3 mm hex head screws (A) through the cartridge

bay and then through the inner floor.

CAUTION: Do not over-tighten the screws. Over-tightening

the screws could damage the inner floor and void the

manufacturer's warranty.

3D Systems, Inc.

Back Left

Back Left View