- ページ 11

3Dプリンター 3D Systems CubeProのPDF オリジナル取扱説明書をオンラインで閲覧またはダウンロードできます。3D Systems CubePro 18 ページ。 Unjamming extruder
3D Systems CubePro にも：マニュアル (11 ページ), オリジナル取扱説明書 (12 ページ)

ページを印刷する

10. Using wire cutters, carefully cut the six (6) zip ties securing the delivery

tube nuts to the inner floor.

CAUTION: Remove all remnants of the wire ties. Any plastic

that may drop into the components can cause damage if left

there.

11. Route the delivery tube nuts to the rounded openings in the inner floor

and push them through.

12. Carefully tilt the inner floor at an angle and pull it out of the printer.

CAUTION: Ensure the heater assembly is properly supported

as you tilt the floor. Place the heater assembly on the printer

outer floor away from other components.

3D Systems, Inc.

Front

Bottom

Top