3D Systems CubePro Оригинальное руководство по эксплуатации - Страница 11
Просмотреть онлайн или скачать pdf Оригинальное руководство по эксплуатации для 3D-принтеры 3D Systems CubePro. 3D Systems CubePro 18 страниц. Unjamming extruder
Также для 3D Systems CubePro: Руководство (11 страниц), Оригинальное руководство по эксплуатации (12 страниц)
Печатать страницу
10. Using wire cutters, carefully cut the six (6) zip ties securing the delivery
tube nuts to the inner floor.
CAUTION: Remove all remnants of the wire ties. Any plastic
that may drop into the components can cause damage if left
there.
11. Route the delivery tube nuts to the rounded openings in the inner floor
and push them through.
12. Carefully tilt the inner floor at an angle and pull it out of the printer.
CAUTION: Ensure the heater assembly is properly supported
as you tilt the floor. Place the heater assembly on the printer
outer floor away from other components.
3D Systems, Inc.
10
Front
Bottom
Top