- ページ 14

3Dプリンター 3D Systems CubeProのPDF オリジナル取扱説明書をオンラインで閲覧またはダウンロードできます。3D Systems CubePro 18 ページ。 Unjamming extruder
3D Systems CubePro にも：マニュアル (11 ページ), オリジナル取扱説明書 (12 ページ)

ページを印刷する

19. Place cartridge bay2 on top of the inner floor. Insert the four (4) 2.5

mm hex head screws through the lower hinges and the inner floor and

attach the four 7 mm nuts. Tighten the nuts.

NOTE: Proceed to step 21 if no other parts are being

replaced.

20. Secure the cartridge sensor assembly to the bottom of cartridge bay 2

by inserting and tightening both (2) 2.5 mm hex head screws.

CAUTION: Do not over-tighten the screws. Over-tightening

the screws could damage the cartridge sensor and void the

manufacturer's warranty.

21. Carefully tilt the inner floor at an angle and place it into the printer.

CAUTION: As you rotate the inner floor horizontally, make

note of the position of the interior heater assembly.

3D Systems, Inc.

Bottom of Inner Floor