3D Systems CubePro 원본 사용 설명서 - 페이지 9
{카테고리_이름} 3D Systems CubePro에 대한 원본 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Systems CubePro 18 페이지. Unjamming extruder
3D Systems CubePro에 대해서도 마찬가지입니다: 매뉴얼 (11 페이지), 원본 사용 설명서 (12 페이지)
페이지 인쇄
REPLACING CARTRIDGE BAYS
4
TOOLS NEEDED
•
2 mm Hex Driver
•
2.5 mm Hex Driver
•
3 mm Hex Driver
•
7 mm wrench
•
8 mm wrench
•
Wire Cutters
REPLACING THE POWER SUPPLY
WARNING: BEFORE SERVICING THESE COMPONENTS, ENSURE YOU ARE WEARING A WELL-GROUNDED
ELECTRO-STATIC DISCHARGE (ESD) STRAP. ESD PROTECTION IS REQUIRED.
WARNING: NEVER PULL ON WIRES TO DISCONNECT THE CONNECTORS. THIS COULD DAMAGE THE WIRES
AND THE CONNECTORS AND VOID THE MANUFACTURER'S WARRANTY.
WARNING: EVEN AFTER THE PRINTER HAS BEEN TURNED OFF AND DISCONNECTED FROM UTILITY POWER, IT
IS POSSIBLE TO STILL CONTAIN RESIDUAL VOLTAGE. EXTREME CAUTION IS REQUIRED.
1.
Remove all print cartridges.
NOTE: Refer to the section titled Replacing A Material Cartridge in chapter 6 of the User Guide.
2.
Move the print pad to its lowest position.
3.
Remove the jet wiper assembly.
Print Pad Calibration
4.
Navigate to the
5.
Once the print pad has raised, turn off the main power switch on the right side of the printer.
6.
Disconnect the power cord from the printer.
WARNING: THE PRINTER MUST BE POWERED OFF AND DISCONNECTED FROM UTILITY POWER.
3D Systems, Inc.
LEVEL
PLATE.
screen and select
8