3D Systems CubePro Manual Petunjuk Asli - Halaman 10
Jelajahi secara online atau unduh pdf Manual Petunjuk Asli untuk Printer 3D 3D Systems CubePro. 3D Systems CubePro 18 halaman. Unjamming extruder
Juga untuk 3D Systems CubePro: Manual (11 halaman), Manual Petunjuk Asli (12 halaman)
Halaman Cetak
7.
Using a 2.5 mm hex nut driver, loosen and remove the four (4) screws
securing the interior heater to the standoffs. Carefully set the heater
aside on top of the printer floor.
8.
Using a 3 mm hex head driver, loosen and remove all nine (9) 3
mm hex head bolts securing the inner floor. Retain the screws for
reassembly.
9.
Lift the front of the floor plate and carefully disconnect the cables from
the cartridge sensors.
3D Systems, Inc.
9