3D Systems CubePro Original Instructions Manual - Page 15
Browse online or download pdf Original Instructions Manual for 3D Printers 3D Systems CubePro. 3D Systems CubePro 18 pages. Unjamming extruder
Also for 3D Systems CubePro: Manual (11 pages), Original Instructions Manual (12 pages)
Print Page
22. Route the delivery tube nuts through the holes in the inner floor and
position them where they will be secured.
23. Using zip ties, secure the delivery tube nuts to the inner floor. Cut off
any excess plastic from the zip ties.
CAUTION: Remove all remnants of the wire ties. Any plastic
that may drop into the components can cause damage if left
there.
24. Reconnect the material cartridge bay sensors.
25. Maneuver the interior heater and position it above the inner floor.
26. Lower the inner floor and align the screw holes with the standoffs
underneath.
3D Systems, Inc.
14
Front
Bottom