3D Systems Cubify CUBEX Duo 교체 매뉴얼 - 페이지 14

{카테고리_이름} 3D Systems Cubify CUBEX Duo에 대한 교체 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Systems Cubify CUBEX Duo 17 페이지. Replacing a main board pcb
3D Systems Cubify CUBEX Duo에 대해서도 마찬가지입니다: 교체 매뉴얼 (13 페이지), 매뉴얼 (10 페이지), 매뉴얼 (10 페이지)

페이지 인쇄
3D Systems Cubify CUBEX Duo 교체 매뉴얼
Fasten one side of the Y belt by placing it between the Y belt clamps and fastening
the two bolts. Apply equal pressure to each bolt to ensure the X motor mount stays
flat.
Pull the unfastened side of the Y belt through its corresponding clamp, pull it taught
with pliers and fasten the two bolts, again applying equal pressure to each bolt to
ensure the X motor mount stays flat.
Plug the X motor wire into the X motor
14