3D Systems Cubify CUBEX Trio 교체 매뉴얼 - 페이지 12

{카테고리_이름} 3D Systems Cubify CUBEX Trio에 대한 교체 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Systems Cubify CUBEX Trio 13 페이지. Print jet replacement manual

Fastening the print tip on a CubeX

A CubeX with a single print jet does not have a second or third nozzle to reference

the print tip level. Instead you have to use the CubeX wiping stick.

1. Power on the CubeX printer

2. Put the CubeX into manual move.

3. Raise the print pad until it is approximately 5mm away from the print tip.

4. Slowly raise the print pad until the print tip is touching it.

5. Continue raising the print pad until there is approximately 0.5mm between the

print pad and the CubeX wiping stick.